SATO XL400/410 - Manual (Page 57)

Programming Manual 2. Command Codes
SATO RISC Printers 57
Job ID Store
Command Structure:
IDaa
aa:
Job ID assigned (01 to 99)
Example: ID09
Placement: Immediately following the A in the job data
stream.
Default: None
Function:
To add an identification number to a job. The status of the job can then
be determined using the ENQ command in the Bi-Com status mode
(See Interface Specifications for more information).
Input:
A
ID02
. . . Job . . .
Z
Output:
There is no printer output as a result of this command.
Note:
1. Works only in Bi-Com mode. The Job ID number must be stored
before Bi-Com status mode can be used.
2. If more than one ID number is sent in a single job, the last number
transmitted will be used, i.e.
A
ID01
. . . . . . . . . .
ID02
. . . . . . . . .