Sanyo VSP-9000 - Manual (Page 51)

English
System Setup 50
Password Setup (PASSWORD)
Passwords can be set for operations upon unit power ON, setup menu access, etc.
enter . 0
D i g i t
p a s s w o r d
S t a r t
enter . 0
D i g i t
p a s s w o r d
A l a r m r e s e t
enter . 0
D i g i t
p a s s w o r d
P a r a m e t e r s
enter . 0
D i g i t
p a s s w o r d
L e v e l 1
enter . 0
D i g i t
p a s s w o r d
L e v e l 2
enter . 0
D i g i t
p a s s w o r d
L e v e l 3
ent
> 1 - A T S W I T C H I N G O N
2 - A L A R M S R E S E T
3 - P A R A M . M O D I F I C A T I O N
4 - G R A P H E N V I R . L E V E L 1
5 - G R A P H E N V I R . L E V E L 2
6 - G R A P H E N V I R . L E V E L 3
P A S S W O R D P A S S W O R D
1-AT SWITCHING ON
2-ALARMS RESET
3-PARAM.MODIFICATION
4-GRAPH ENVIR. LEVEL 1
5-GRAPH ENVIR. LEVEL 2
6-GRAPH ENVIR. LEVEL 3
Password required upon alarm reset
Password required upon power ON
Password required upon accessing setup
menu
Password required to enter Graphics
Environment Setup Level 1
Password required to enter Graphics
Environment Setup Level 2
Password required to enter Graphics
Environment Setup Level 3
• Write down each password to
remember them. Also, periodic
password changes are recommended
for safety.
• When purchased, the password is set
to “00000”. When no password is
required, set it as “00000”.
• When the unit is initialized, all
passwords become “00000”.
• When a password is set, an entry
screen will appear, requesting your
password (example: upon power ON).
Enter the password that is set.
• When the wrong password is entered,
“Password not enabled” is displayed.
Enter the correct password.