Sony Ericsson TT4031 (SE-GM29) - Manual (Page 72)

Owner’s Manual Rev 1.0 Page 72 of 72
Description
0 Disable automatic answer. Default value
1-7 Answer after the specified number of rings
3.3 ATS2 Escape Sequence Character
Description Command Possible Responses
Set escape sequence
character
ATS2=[] •_ OK
•_ ERROR
Read the current setting ATS2
Show if the command is
supported
ATS2=? S2: (list of supported
s)
Defines the character to be used as the escape sequence character when
switching from on-line data mode to on-line command mode. The response to
the command is modified to reflect the change.
Description
43 Escape sequence character. Default value
0 to 255 Escape sequence character
NOTE! - If the parameter is set to a value in the
range of 128-255, the escape sequence detection is
disabled.