Sony Ericsson TT4031 (SE-GM29) - Manual (Page 267)

Owner’s Manual Rev 1.0 Page 267 of 267
Description
129 129 ISDN/telephony numbering plan,
national/international unknown
145 145 ISDN/telephony numbering plan, international
number
161 161 ISDN/telephony numbering plan, national number
128-255 Other values refer to GSM 04.08 section 10.5.4.7
16.15 AT+CLIR Calling Line Identification Restriction
Description Command Possible Responses
Request calling line
identification restriction
AT+CLIR=[] •_ +CME ERROR
•_ OK
•_ ERROR
Read the current setting AT+CLIR? •_ +CLIR: ,
•_ +CME ERROR
•_ OK
•_ ERROR
Test if the command is
supported
AT+CLIR=? •_ +CLIR: (list of supported
s)
•_ +CME ERROR
•_ OK
•_ ERROR
This command refers to CLIR-service according to GSM 02.81 that allows a
calling subscriber to enable or disable the presentation of the CLI to the
called party when originating a call.
Set command overrides the CLIR subscription (default is restricted or
allowed) when temporary mode is provisioned as a default adjustment for all
following outgoing calls. Using the opposite command can revoke this
adjustment. If this command is used by a subscriber without provision of
CLIR in permanent mode the network will act according GSM 02.81.
The setting shall be per logical channel.
When the MS is turned off and then turned on again the parameter setting
shall turn back to default, i.e. the presentation of CLI shall be used
according to the subscription of the CLIR service, is 0.