Sony Ericsson TT4031 (SE-GM29) - Manual (Page 269)

Owner’s Manual Rev 1.0 Page 269 of 269
Test if the command is
supported
AT+CSSN=?
•_ +CSSN: (list of
supported s),(list
of supported s)
•_ +CME ERROR
•_ OK
•_ ERROR
This command refers to supplementary service related network initiated
notifications. The set command enables or disables the presentation of
notification result codes from TA to TE.
When =1 and a supplementary service notification is received after a
mobile originated call setup, unsolicited result code +CSSI:
[,] is sent to TE before any other MO call setup result codes
presented in this ETS or in V.25ter. When several different s are
received from the network, each of them shall have its own +CSSI result
code.
When =1 and a supplementary service notification is received during a
mobile terminated call setup or during a call, or when a forward check
supplementary service notification is received, unsolicited result code +CSSU:
[,] is sent to TE. In case of MT call setup, result code is sent
after every +CLIP result code (refer command “Calling line identification
presentation +CLIP”) and when several different s are received from
the network, each of them shall have its own +CSSU result code.
Note!_ The difference between and is
that is a position mark while is a
unique value for each CUG. is not
supported.
Test command returns values supported by the TA as a compound value.
Description
0 Disable the +CSSI result code presentation status in the
TA
1 Enable the +CSSI result code presentation status in the
TA
Description
0 Disable the +CSSU result code presentation status in the
TA
1 Enable the +CSSU result code presentation status in the
TA