Juniper Networks G10 CMTS User Manual
G10 cmts, Release 3.0
Table of contents
Document Outline
- Table of Contents
- About This Manual
- Product Overview
- System Overview
- Hardware Component Overview
- System Architecture Overview
- Initial Installation
- Prepare the Site
- Safety Precautions
- Notices
- Power
- Environment
- Mounting
- Tools and Equipment Required for Installation
- Coaxial Cable Requirements
- Characterization of Installation Site
- Summary Checklist
- Noise Measurement Methodology
- Additional Characterization Tables
- Verification of Shipping Cartons
- G10 CMTS Installation Checklist
- Install the CMTS
- Ground the Chassis
- Rack Mounting
- Install Power Supplies
- Install a DOCSIS Module
- Install an HFC Connector Module or SIM
- Install a Chassis Control Module
- Install a Hard Disk Module
- Install a NIC Module
- Install a NIC Access Module
- Cable an HFC Connector Module or SIM
- Cable a Chassis Control Module
- Cable a NIC Module
- Cable a NIC Access Module
- Attach a PC to the Chassis Control Module
- Connect to Power Sources
- Connect the Power and Perform Initial Configuration
- Prepare the Site
- Troubleshooting and Maintenance
- Appendixes
- Index