Juniper Networks G10 CMTS - Manual (Page 185)

•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Replacement Procedures
Module Removal
169
Figure 48: HFC Connector Module Removal
Remove a Chassis Control Module
The Chassis Control Module is hot-swappable. However, if you hot-swap the Chassis Control
Module, all services supported by the CMTS are lost because the CMTS cannot operate
without the Chassis Control Module.
To remove a Chassis Control Module, follow this procedure:
1. Stop the CMTS software by issuing the request system halt command:
user@host> request system halt
2. Power down the CMTS.
3. Follow the same procedure described in “Remove a DOCSIS Module” on page 166.
3
Eth0
Eth1
US 3
US 2
US 1
US 0
DS 3
DS 2
DS 1
DS 0
1
1
2
2