Tools and equipment required for installation, 74 tools and equipment required for installation – Juniper Networks G10 CMTS User Manual

Page 90

Tools and Equipment Required for Installation

•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•

JUNOSg 3.0 G10 CMTS Hardware Guide

Tools and Equipment Required for Installation

You need the following tools to complete the G10 CMTS installation:

! M2.5 Phillips torque screwdriver

! M2.5 flathead torque screwdriver

! M3 Phillips torque screwdriver

! M5 Phillips torque screwdriver

! #10 Phillips torque screwdriver

! #10 flathead torque screwdriver

! #12 Phillips torque screwdriver

! 7/16 in. torque wrench

! 22-10 AWG crimper/cutter/stripper

In addition, you might need the following supplies:

! RF cables and adapters

! Ethernet cables with RJ-45 connectors

You need the following equipment to configure the G10 CMTS and verify that the RF system
has been set up properly:

! PC with asynchronous terminal emulation

! RF spectrum analyzer

! RF power meter