Juniper Networks G10 CMTS - Manual (Page 146)

Perform Initial Software Configuration
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
JUNOSg 3.0 G10 CMTS Hardware Guide 130
12. Optionally, configure additional properties by adding the necessary configuration
statements. Then, commit the changes to activate them on the CMTS.
[edit]
root@host-name# commit
13. When you have finished configuring the CMTS, exit configuration mode.
[edit]
root@host-name# exit
root@host-name>
The CMTS is now connected to the network but is not fully configured. You must perform
additional configuration before the CMTS can pass traffic. For complete information about
configuring the CMTS, including examples, see the JUNOSg software configuration guides.