Juniper Networks G10 CMTS - Manual (Page 186)

Module Removal
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
JUNOSg 3.0 G10 CMTS Hardware Guide 170
Remove a Hard Disk Module
To remove a Hard Disk Module, follow this procedure:
1. Stop the CMTS software by issuing the request system halt command:
user@host> request system halt
2. Power down the CMTS.
3. Follow the same procedure described in “Remove an HFC Connector Module or SIM” on
page 168.
Remove a NIC Module
The NIC Module is hot-swappable, so you can remove it or install it while the CMTS is
powered on. To remove a NIC Module, follow the same procedure described in “Remove a
DOCSIS Module” on page 166.
Remove a NIC Access Module
The NIC Access Module is hot-swappable, so you can remove it or install it while the CMTS is
powered on. To remove a NIC Access Module, follow the same procedure described in
“Remove an HFC Connector Module or SIM” on page 168.