JVC CA-NXHD10R - Manual (Page 68)

– 63 –
8
If necessary, press SELECT ¢ or SELECT 4 to
precisely adjust the end point.
The unit repeats the newly selected end point.
• You can shift the end point up to ±128. This range
(±128) corresponds to about ±12 seconds from the
original point (ADJUST 0).
9
Press SET.
Playback stops, and the library selection screen
appears.
10
Press LIBRARY to select a library (“Library 1”—
“Library 10”) you want to copy the selected album
into, then press
SET.
Album number is automatically assigned to a newly
created album (the youngest unused number will be
selected).
The confirmation screen appears in the main display.
11
Press ENTER.
The HDD lamp flashes in red.
“PLEASE WAIT” then “HDD WRITING” appears
while the editing you have made is being stored in the
HDD.
• It takes a long time if you have copied a long portion.
The currently selected library flashes.
Ex. When selecting “Library 9”
Moving a Track—MOVE
You can move a track either within the same album or into
a different album.
Tracks are automatically renumbered in both albums—
where a track has been moved from and where the track has
moved to.
On the remote control ONLY:
If the HDD includes many albums and tracks, select the
album and track using Search Mode (see page 38) before
performing the procedure below.
1
Press TITLE/EDIT repeatedly until “TRACK EDIT?”
appears in the main display, then press SET.
• The source changes to “HDD” automatically if
another source has been selected.
2
Press SELECT ¢ or SELECT 4 to select
“MOVE?,” then press SET.
C D E A B
C D A B
After moving
track 2
Track No.
1st 2nd 3rd 4th 5th
1st 2nd 3rd 4th 5th
E
Ex. When moving Track 2 (Song B) in front of Track 5 in
the same album
The currently selected track
number of the current album
flashes.
EN62-66_NXHD10R[B]f.pm6 02.6.24, 9:10 AM 63