JVC CA-NXHD10R - Manual (Page 13)

– 8 –
Connecting Other Equipment
You can connect a cassette deck, etc.—used as a playback
and recording device.
When you connect the other equipment, refer also to the
manuals supplied with it.
• DO NOT connect other equipment while the
power is on.
• DO NOT plug in any equipment until all
connections are complete.
Be sure that the plugs of the audio cords and the jacks on
the rear of the unit are color coded: White plugs and jacks
are for left audio signals, and red ones for right audio
signals.
Ex. When connecting a cassette deck
By using audio cords (not supplied), connect:
• Between the audio input jacks on the cassette deck and
the LINE OUT jacks—For recording on the cassette
deck.
• Between the audio output jacks on the cassette deck and
the LINE IN jacks—For playing a tape.
R
L
L
R
R
L
L
R
To remove the speaker grille
The speaker grilles are removable as shown below:
To remove the speaker grille, insert your fingers at the top
of the speaker grille, then pull towards you. Do the same at
the bottom.
To attach the speaker grille, put the projections of the
speaker into the holes of the speaker grille.
Projections Holes
Speaker grille
Continued
To input (REC)
To output (PLAY)
Ex. Cassette deck
LINE IN
LINE OUT
EN01-09_NXHD10R[B]f.pm6 02.6.24, 8:57 AM 8