JVC CA-NXHD10R - Manual (Page 52)

– 47 –
To change the information shown in the main display
while recording
Each time you press
DISP/CHARA on the remote control,
the information in the main display changes as follows:
1 Preset station number if any
2 Station frequency
3 PS name (see page 20)
4 Remaining recording time in the HDD (counts
down every 13 seconds), calculated based on the
current setting of the recording mode
5 Current recording mode
If “TU AUTO REC OFF PLEASE!” appears in the
main display
You have tried to select recording modes or start recording while
Tuner Auto Recording is performed. These operations cannot be
accepted during Tuner Auto Recording.
If you want to record the current broadcast program
for more than 30 minutes
With this function, you can record only the most recent 30 minutes
of the program. To record the entire program, first deactivate the
Tuner Auto Recording, then perform the recording procedure
explained on page 49.
Recording CDs
This unit is equipped with the following recording modes
to record CDs.
• AAC128kbps : To record in AAC format at the bit rate
of 128 kbps (normal speed).
• AAC 96kbps : To record in AAC format at the bit rate
of 96 kbps (normal speed).
• PCM x1 REC : To record in Linear PCM format
(normal speed).
• PCM x2 REC : To record in Linear PCM format at
double normal speed. (No playback
sound will be heard while recording.)
• PCM x4 REC*: To record in Linear PCM format at four
times normal speed. (No playback
sound will be heard while recording.)
* You cannot select “PCM x4 REC” to record Program play and
Random play.
X 4
PCM
Current recording
mode setting
1
Prepare a CD.
• Press CD
3/8, then press 7 after loading a CD.
• You can make a program (see page 29) or select
Random play mode (see page 30) if you want. In this
case, do not start playing CD manually.
2
Press REC MODE on the unit to select the recording
mode.
• Each time you press the button, the recording modes
change as follows:
The indicator corresponding to the selected recording
mode lights up on the display.
3
Press REC START to start recording.
The REC indicator starts flashing on the display, and
CD play and recording start at the same time.
• Repeat play is temporarily canceled if in use.
* Remaining recording time is calculated based on the
current setting of the recording mode.
When CD play ends, recording also stops and the
following message appears in the main display.
AAC128kbps AAC 96kbps
PCM x1 REC
PCM x2 REC PCM x4 REC
Remaining play time
of the current track
Remaining recording time in the HDD *
Current track no. of
the CD
REC
indicator
* 1
X 4 REC
PCM
Ex. When selecting “PCM x4 REC”
Clock
1 2 4
5 3
EN42-51_NXHD10R[B]f.pm6 02.6.24, 9:06 AM 47