JVC CA-NXHD10R - Manual (Page 20)

– 15 –
Reinforcing the Bass Sound
The richness and fullness of the bass sound is clearly
maintained regardless of how low you set the volume
—Active Hyper Bass Pro.
• You can use this effect only for playback.
• This function also affects the sound from headphones.
On the remote control ONLY:
To get the effect, press
AHB PRO repeatedly until
“AHB 1” or “AHB 2” appears in the main display.
The BASS indicator lights up on the display.
• Each time you press the button, the Active Hyper Bass
Pro mode changes as follows:
• “AHB 2” is more effective than “AHB 1.”
To check the effect level, press AHB PRO once.
To cancel the effect, press AHB PRO repeatedly until
“AHB OFF” appears in the main display.
The BASS indicator goes off from the display.
AHB 1 AHB 2
AHB OFF
(canceled)
Adjusting the Bass and Treble Sounds
You can adjust bass and treble sounds to your taste and
surroundings.
• You can use this effect only for playback.
• This function also affects the sound from headphones.
On the remote control ONLY:
1
Press TONE CONTROL to select “BASS” or
“TREBLE.”
The selected tone control mode and the current setting
appear in the main display.
• Each time you press the button, the tone control
mode changes as follows:
2
Press VOLUME + or VOLUME – to adjust the
selected tone level.
• You can adjust the tone level within the range of –5
to +5.
3
Repeat steps 1 and 2 to adjust the other tone level.
4
Press TONE CONTROL to finish the setting.
• If you do not press the button for about 5 seconds, the
setting will be stored, then the source indication will
be resumed.
To check the current level, press TONE CONTROL
repeatedly.
BASS TREBLE
Source indication
(canceled)
Ex. “BASS” level is set to “+3”
BASS indicator BASS
AAC 128
Ex. When “AHB1” is selected
EN10-16_NXHD10R[B]f.pm6 02.6.24, 8:59 AM 15