JVC VR-609 - Manual (Page 69)

-- 69 --
VR-609
・ON/OFF of overwrite is switched by the existence of the check of "overwriting
automatically, when the residual quantity of HDD is lost."
・Monitor screen displays a similar message as the following according to overwrite
on/off.
Overwrite On
・Main HDD is full, it starts to overwrite old DATA. Displays only the time date.
Overwrite Off
・When Main HDD is full (100%), recording is stopped. Displays the residual
quantity of HDD on the right hand of the time date.
■ Initialize
・If you check "Clear All Previous Log", and press EXIT button, "Do you want to
Update Disk?" is displayed. As pressing "Yes" button, Log information will be
deleted.
・It is better to initiate Log, when HDD or DATA is changed.
5.7.3.3 Clear All Previous Log
5.7.3.2 Overwrite Disk When Disk Full
! A system log is not deleted even if the HDD is initialized.
・If you press "Initialize" button at Main HDD, "Data stored in HDDs numbered
larger than x will be lost. Are you sure?" is displayed. As pressing "Yes" button,
HDD will initialized. Please note all HDD for main after specified HDD is initialized.
・If you press "Initialize" button at backup HDD, "All data in HDD x will be lost.
Are you sure?" is displayed. As pressing "Yes" button, HDD will be initialized.
・When Overwrite is set to OFF, displays the warning message.
・If cursor is united with the position of "displaying a message if the amount used
becomes more than X %" and an execution button is pushed, the rate which displays
the warning of HDD residual quantity can be set up.
5.7.3.4 Disk Full Message
・It is displayed when the capacity specified on the hard disk
management screen is exceeded.