JVC DR-M10 - Manual (Page 95)

Masterpage:Right0
EN
95
Filename [DR-M10U_10Editing.fm]
Page 95 January 16, 2004 6:53 pm
SYSTEM CONNECTIONS
Connecting To A Dolby Digital Decoder
or An Amplifier With Built-in DTS
These instructions enable you to connect your unit to a Dolby Digital decoder or an amplifier with built-in DTS.
Make connections.
Connect the unit and a Dolby Digital decoder or an
amplifier with built-in DTS using either an optional
optical cable or an optional coaxial cable.
NOTES:
● For Dolby Digital sound, set “DIGITAL AUDIO OUT” to
“DOLBY DIGITAL/PCM”. (
੬
pg. 97)
● For DTS sound, set “DIGITAL AUDIO OUT” to “STREAM/
PCM”. (
੬
pg. 97)
CAUTIONS:
● This unit has a dynamic range of more than 110 dB with
regards to its Hi-Fi audio capability. It is recommended that
you check the maximum level if you are going to listen to the
Hi-Fi audio signals through a stereo amplifier. A sudden surge
in the input level to the speakers may damage them.
● Some speakers and televisions are specially shielded to
prevent television interference. If both are of the non-shielded
type, do not place the speakers adjacent to the TV set as this
can adversely affect the playback picture.
1
PCM STREAM AV COMPU LINK
CABLE BOX
LEFT
AUDIO
RIGHT
LEFT
VIDEO
S-VIDEO VIDEO
S-VIDEO
L-1
L-1 L-2
L-2
AUDIO
RIGHT
COMPONENT COAXIAL OPTICAL
Y
PB
PR DIGITAL OUT
OUTPUT INPUT
IN
OUT
ANTENNA
Back of unit
Note for connection:
Remove the protection cap
from the optical cable.
Optical cable
(not supplied)
Dolby Digital
decoder or
amplifier with
built-in DTS
To DIGITAL AUDIO
input Coaxial cable
(not supplied)
DIGITAL OUT
(OPTICAL) DIGITAL OUT
(COAXIAL)
DR-M10U_01.book Page 95 Friday, January 16, 2004 7:38 PM