JVC DR-M10 - Manual (Page 33)

Masterpage:Right-No-Heading
EN
33
Filename [DR-M10U_06-2Initial Set.fm]
Page 33 March 4, 2004 5:15 pm
Setting DBS receiver’s brand and
channel
After installation, set the DBS receiver’s brand and
channel correctly; otherwise, the Controller cannot work
correctly.
A
Turn on the DBS receiver.
Turn on the DBS receiver’s power.
B
Access the Main Menu screen.
Press SET UP.
C
Access the “DBS RECEIVER SET” screen.
D
Select the DBS receiver’s channel.
Your selection depends on how the DBS receiver is
connected to your unit.
A Press rt to move the
arrow to “DBS RECEIVER
OUTPUT CH”, then press
ENTER.
B If the DBS receiver is
connected to your unit’s
ANTENNA IN connector
on the rear panel, press
rt to select the channel number representing the
DBS receiver’s output (CH3 or CH4), then press
ENTER.
If the DBS receiver is connected to your unit’s
AUDIO/VIDEO INPUT connectors on the rear panel,
press rt to select “L-1” or “L-2”, then press ENTER.
If you do not use a DBS receiver, press rt to select
“OFF”, then press ENTER.
CABLE/DBS
DVD TV
DVD
CH
TIMER REC LINK PROG/CHECK VCR Plus+
NEXT PREVIOUS
PAUSE REC
REC MODE LIVE CHECK
SET UP DISPLAY ON SCREEN
OPEN/
CLOSE
AUDIO SUBTITLE ANGLE
PROGRESSIVE
SCAN
SLOW SLOW PLAY/SELECT
STOP/ CLEAR
NAVIGATION TOP MENU
RETURN
ENTER
MENU
TV/CBL/DBS
STANDBY/ON TV
MUTING
TV/
VIDEO
TV VOLUME ABC
JKL GHI MNO
TUV PQRS WXYZ
AUX CANCEL MEMO/MARK
DBS
DEF
rtwe
ENTER
● Turn on the unit.
● Turn on the TV and select the AV mode.
● Slide the TV/CABLE/DBS/DVD switch to DVD.
A Press w e to move the
arrow to “INITIAL SET
UP”, then press ENTER.
B Press w e to move the
arrow to “STB SET”, then
press ENTER.
C Press rt to move the
arrow to “DBS RECEIVER
SET”, then press ENTER.
DR-M10U_06-2Initial Set.fm Page 33 Thursday, March 4, 2004 5:15 PM