Recording initializing, Attention, Symptom possible cause corrective action – JVC DR-M10 User Manual
Page 105
Masterpage:Right-No-Heading
EN
105
Filename [DR-M10U_11Subsidiary.fm]
Page 105
March 5, 2004 11:53 am
RECORDING
INITIALIZING
SYMPTOM
POSSIBLE CAUSE
CORRECTIVE ACTION
1. The desired program cannot be
recorded.
● The channel position does not
correspond to that in the receiving area.
Set the correct channel position for the
receiving broadcast. (
2. Recording and editing cannot be
made.
● No disc or a disc not being compatible
with the unit is loaded.
Load a recordable disc on the unit.
(
● The disc loaded is not formatted.
Format the disc. (
● A finalized DVD-R disc is loaded.
Recording and editing cannot be made on
finalized discs. (
pg. 102) Load a
recordable disc on the unit.
● The disc is full or does not have enough
space for the program to be recorded.
Clear unnecessary programs on the disc or
load a blank disc. (
● The protect tab on the DVD-RAM
cartridge is set to the protect position.
Release the protect tab. (
੬
3. Timer programing cannot be made.
● Date and time is not correct.
Set date and time correctly. (
੬
pg. 24)
4. Timer programing recording does not
start.
● Power failure occurred before the timer
programed recording starts.
Check the timer programing. (
5. VCR Plus+ Timer Programing cannot
be made.
● Date and time set on the unit is not
correct.
Set date and time correctly. (
੬
pg. 24)
● The channel position does not
correspond to that in the receiving area.
Set the correct channel position for the
receiving broadcast. (
੬
pg. 26)
6. Satellite Auto Recording recording
does not start.
● The DBS receiver is not connected
properly to this unit.
Connect the DBS receiver to the AUDIO/
VIDEO INPUT (L-1) connector properly.
(
੬
pg. 32)
7. On the front display panel, “– –:– –”
appears.
● Power failure occurred.
Set date and time correctly. (
੬
pg. 24)
8. “PROGRAM FULL” appears on the TV
screen during timer programing.
● Eight programs have already been timer
programed.
Clear unnecessary programs on the unit,
then try timer programing again.
(
੬
pg. 69)
9. The disc space does not increase when
recorded programs are cleared.
● The PC’s data recorded on a DVD-RAM
drive cannot be cleared on this unit.
Format the disc. (When the disc is soiled,
wipe the disc with a soft dry cloth before
formatting.) (
੬
pg. 11, 101)
SYMPTOM
POSSIBLE CAUSE
CORRECTIVE ACTION
1. Malfunction occurs on the unit.
—
Press 1 to turn off the unit, press and
hold 1, then press 8 for two seconds or
more.
2. The Disc Tray doesn’t open.
—
Take out the disc in following ways.
● Connect and the disconnect the power
cord from the main outlet.
● Press and hold the open/close button
(
x
) on the unit until the disc tray opens.
(it will take about 30sec.)
● Close the disc tray by pressing the open/
close button after taking out the disc.
(the main power shuts down.)
ATTENTION:
This unit contains microcomputers. External electronic noise or interference could cause malfunctioning. In such cases, switch the
unit off and unplug the mains power cord. Then plug it in again and turn the unit on. Take out the disc. After checking the disc,
operate the unit as usual.
DR-M10U_11Subsidiary.fm Page 105 Friday, March 5, 2004 11:54 AM