JVC RX-9010VBK - Manual (Page 59)

56
English
Automatic Power On/Off (Standby): only possible
with the COMPU LINK-3 and COMPU LINK--4
connection
Automatic Power On:
• When you turn on the receiver by pressing POWER on the
front panel or AUDIO POWER ON on the remote control
(with MAIN ROOM/SUB ROOM selector set to “MAIN
ROOM”):
OR
When you turn on the main room sound by pressing MAIN
ROOM ON/OFF while the receiver is turned on:
\ The MAIN ROOM indicator and the source name for the main
room light up on the display, and one of the connected
components will turn on automatically, depending on which
component has been previously selected as the main room
source.
• When you turn on the receiver by pressing
AUDIO POWER ON on the remote control (with MAIN
ROOM/SUB ROOM selector set to “SUB ROOM”):
OR
When you turn on the sub-room sound by pressing
SUB ROOM ON/OFF while the receiver is turned on:
\ The SUB ROOM indicator lights up on the display, and one of
the connected components will turn on automatically,
depending on which component has been previously selected
as the sub-room source.
Automatic Power Off (Standby):
• When you turn off the receiver by pressing POWER, the
connected components will turn off (standby).
• When you turn off the main room sound by pressing
MAIN ROOM ON/OFF, the selected main room source
component turns off (unless the same component is selected as the
sub-room source).
– If the SUB ROOM indicator is lit on the display, the main room
source will stop playing, but will not turn off.
• When you turn off the sub-room source by pressing
SUB ROOM ON/OFF, the selected sub-room source component
turns off (unless the same component is selected as the main room
source).
– If the MAIN ROOM indicator is lit on the display, the sub room
source will stop playing, but will not turn off.
Synchronized Recording
This operation is only possible while the receiver is ready for the
main room operations.
Synchronized recording means the cassette deck (or MD recorder)
starts recording as soon as a CD begins playing.
• When using a CD player for synchronized recording, refer to the
manual supplied with it.
To use synchronized recording, follow these steps:
1. Put a tape in the cassette deck (or an MD in the
MD recorder), and a disc in the CD player.
2. Press the record (
¶) button and the pause (8)
button on the cassette deck (or MD recorder) at
the same time.
This puts the cassette deck (or MD recorder) into recording
pause.
If you do not press the record (
¶) button and pause (8) button at
the same time, the synchronized recording feature will not
operate.
3. Press the play (
3) button on the CD player.
The main room source changes on the receiver, and as soon as
play starts, the cassette deck (or MD recorder) starts recording.
When the play ends, the cassette deck (or MD recorder) enters
recording pause, and stops about 4 seconds later.
Notes:
• During synchronized recording;
– the selected main room source cannot be changed. (You can
change the sub-room source.)
– If the same source is selected both for the main room and the
sub-room, operating the sub-room source will affect the
recording.
• The COMPU LINK remote control system may not operate properly
during synchronized recording;
– If the power of any component is shut off.
– If the main room sound is turned off by pressing
MAIN ROOM ON/OFF.
In this case, you must start again from the beginning.
EN50-61.RX-9010VBK[C]f 01.4.13, 5:40 PM 56