JVC RX-9010VBK - Manual (Page 37)

34
English
Basic Setting and Adjustment — Auto
Memory
Without any setting required, this receiver stores different sound
settings for each different playing source automatically whenever
you do the following:
• Turning on the power (see page 17)
• Changing the source to play (see page 18)
• Changing the source name (see page 33)
So, you do not have to change the sound settings next time you
select the same source. The stored settings for the selected source
are automatically recalled.
The following settings are automatically stored for each source:
• Analog/digital input mode (see page 31)
• Bass boost (see page 21)
• Digital equalization adjustment (see page 20)
• DVD MULTI playback mode setting (see page 49)
• Front speaker output balance (see page 27)
• Input attenuator mode (see page 21)
• Line direct (see page 22)
• Midnight mode (see page 21)
• Subwoofer setting and its output level (see pages 21 and 28)
• Surround mode on/off (see page 39)
• Surround/DSP mode setting (see pages 40 – 48)
You can also assign and store the volume level for each source. See
“To store the volume level” to the right.
Notes:
• This function cannot be used for the sub-room sources.
• If the source is FM or AM, you can assign different settings for each
band.
• You cannot assign and store different settings for digital input mode
and analog input mode (when selecting a digital source).
• The Surround modes and DSP modes cannot be used with DVD
MULTI playback mode at the same time.
To store the volume level
(ONE TOUCH OPERATION)
Before you start, remember....
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
On the front panel ONLY:
1. Press SETTING repeatedly until “ONE TOUCH”
appears on the display.
The display changes to show the current setting.
2. Press CONTROL UP
5/DOWN ∞ to turn on the
One Touch Operation.
The ONE TOUCH OPERATION indicator lights up on the
display.
• Each time you press the button, the one touch operation
function turns on (“ON”) and off (“OFF”).
To recall the volume level
With the ONE TOUCH OPERATION indicator lit, the volume level
for the currently selected source is recalled when the source is
selected.
To cancel the One Touch Operation
Select “OFF” in step 2 above so that the ONE TOUCH
OPERATION indicator goes off. (Even though the One Touch
Operation is canceled, the recalled volume remains active.)
CONTROL
DOWN UP
SETTING
EN27-36.RX-9010VBK[C]f 01.4.13, 5:39 PM 34