English – JVC RX-9010VBK User Manual

Page 25

English

Using the Sleep Timer

Using the Sleep Timer, you can fall asleep to music and know the
receiver will turn off by itself rather than play all night.

From the remote control ONLY:

Press SLEEP repeatedly.

The SLEEP indicator lights up on the display, and the
shut-off time changes as follows (in minutes):

When the shut-off time comes
The receiver turns off automatically.
• If the sub-room source is still played (the SUB ROOM and

SPEAKERS SUB ROOM indicators are lit on the display) when
the shut-off time comes, the receiver will not turn off, but only the
main room sound will shut off.

To check or change the time remaining until the shut-off time
Press SLEEP once.
The remaining time until the shut-off time appears in minutes.
• To change the shut-off time, press SLEEP repeatedly.

To cancel the Sleep Timer
Press SLEEP repeatedly until “SLEEP 0min” appears on the display.
(The SLEEP indicator goes off.)
• Turning off the power also cancels the Sleep Timer.

Recording a Source

For analog-to-analog recording

You can record any analog source through the receiver to —
• the cassette deck (or MD recorder) connected to the TAPE/MD

jacks,

• the VCRs connected to the VCR 1 and VCR 2 jacks, and
• the CD recorder connected to the CDR jacks
— at the same time.

For digital-to-digital recording

You can record the currently selected digital input source through
the receiver to a digital recording device connected to the DIGITAL
OUT terminal.

Notes:

• Analog-to-digital and digital-to-analog recordings are not possible.
• The output volume level, Midnight Mode (see page 21), Bass Boost

(see page 21), Digital Equalization (see page 20), Surround/DSP
modes (see page 37) cannot affect the recording.

• The test tone signal (see pages 40) does not come out through the

DIGITAL OUT terminal.

IMPORTANT:

• While recording, do not turn off the receiver or main room source;

otherwise, recording will stop.

• If the same source is selected both for the main room and the

sub-room, operating the sub-room source will affect the recording.

(Canceled)

DIMMER

From the remote control

SLEEP

Selecting the Line Direct Function

You can enjoy the sound closer to original source by skipping the
sound adjustments such as Digital Equalization and Midnight Mode.
Only the volume level and Bass Boost are adjustable when the Line
Direct function is turned on.
• You can do this setting for each source.

Press LINE DIRECT.

The LINE DIRECT lamp on the front panel button lights up.

• Each time you press the button, the Line Direct function turns on

(“DIRECT ON”) and off (“DIRECT OFF”).
– Select “DIRECT ON” to activate the Line Direct function.

The LINE DIRECT lamp on the front panel button lights up.

– Select “DIRECT OFF” to cancel it.

The LINE DIRECT lamp on the front panel button goes off.

Notes:

• This function is applied only to the main room sources.
• If you turn on the Line Direct function while using the Surround and

DSP modes, the effect changes as follows:

• Turning off the Line Direct function activates the sound adjustments

previously selected such as the Digital Equalization and Midnight
Mode.

Changing the Display Brightness

You can dim the display.

Press DIMMER.

• Each time you press the button, the display dims and brightens

alternately.

Note:

Even though you have made the display dimmer, it brightens for a
while when you operate the receiver (except SURROUND ON/OFF,
source selecting buttons, MAIN ROOM ON/OFF, SUBROOM ON/OFF,
and SUB ROOM CONTROL).

Mode

Surround

DSP

Input

Analog

Not valid

Digital

Valid

Not valid

LINE DIRECT

On the front panel

EN14-26.RX-9010VBK[C]f

01.4.13, 5:38 PM