JVC RX-9010VBK - Manual (Page 36)

33
English
Showing the Text Information on the
Display
When you have connected an MD recorder or CD player equipped
with TEXT COMPU LINK remote control system (see page 57),
you can show the text information, such as disc title or track title,
on the display of this receiver. To show it on the display, follow the
procedure below.
Before you start, remember....
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
On the front panel ONLY:
1. Press SETTING repeatedly until “FL DISP”
(Display) appears on the display.
The display changes to show the current setting.
2. Press CONTROL UP 5/DOWN ∞ to select either
the source name or the text information to be
shown on the display.
• Each time you press the button, the display changes to show
the following:
NORM: Source name and Surround/DSP appear during
play.
TEXT: Text information appears during play.
Note:
Though you have selected “TEXT,” the source name and Surround/
DSP mode appear if a playing disc has no text information.
SETTING
NORM
(Normal)
TEXT
CONTROL
DOWN UP
TAPE / MD
SOURCE NAME
Changing the Source Name
When you have connected an MD recorder to the TAPE/MD jacks
or the DBS tuner to the TV SOUND/DBS jacks on the rear panel,
change the source name which will be shown on the display when
you select the MD recorder or DBS tuner as the source.
• When you select DBS as a source for the sub-room, you cannot
change the source name.
On the front panel ONLY:
When changing the source name from “TAPE” to
“MD”:
•
Press and hold SOURCE NAME (TAPE/MD)
until “ASSGN. MD” appears on the display.
When changing the source name from “TV ” to
“DBS”:
•
Press and hold SOURCE NAME (TV SOUND/
DBS) until “ASSGN. DBS” appears on the
display.
To change the source name to “TAPE” or “TV,” repeat the same
procedure above — press and hold SOURCE NAME (TAPE/MD)
to select “TAPE,” or press and hold SOURCE NAME (TV
SOUND/DBS) to select “TV.”
Note:
Without changing the source name, you can still use the connected
components. However, there may be some inconvenience.
• “TAPE” or “TV SOUND” will appear on the display when you select
the MD recorder or DBS tuner.
• You cannot use the digital input (see page 30) for the MD recorder.
• You cannot use the COMPU LINK remote control system (see page
55) to operate the MD recorder.
TV SOUND/DBS
SOURCE NAME
EN27-36.RX-9010VBK[C]f 01.4.13, 5:39 PM 33