JVC RX-9010VBK - Manual (Page 16)

13
English
Connecting the Power Cord
Before plugging the receiver into an AC outlet, make sure that all
connections have been made.
Plug the power cord into an AC outlet.
Keep the power cord away from the connecting cables and the
antenna. The power cord may cause noise or screen interference. We
recommend that you use a coaxial cable to connect the antenna,
since it is well-shielded against interference.
Note:
The preset settings such as preset channels and sound adjustment
may be erased in a few days in the following cases:
– When you unplug the power cord.
– When a power failure occurs.
CAUTIONS:
• Do not touch the power cord with wet hands.
• Do not pull on the power cord to unplug the cord. When
unplugging the cord, always grasp the plug so as not to damage
the cord.
Putting Batteries in the Remote Control
Before using the remote control, put two supplied batteries first.
1. On the back of the remote control, remove the
battery cover.
2. Insert batteries. Make sure to match the polarity:
(+) to (+) and (–) to (–).
3. Replace the cover.
If the remote control cannot transmit signals and operate the
receiver correctly, replace the batteries. Use two R6P(SUM-3)/
AA(15F) type dry-cell batteries.
Notes:
• When you can aim the remote control directly at the remote sensor
on the receiver, you can operate the receiver at a distance of up to
23 feet (7 m).
• After replacing the batteries, set the manufacturers’ codes again
(see page 68).
CAUTIONS:
Follow these precautions to avoid leaking or cracking cells:
• Place batteries in the remote control so they match the polarity: (+)
to (+) and (–) to (–).
• Use the correct type of batteries. Batteries that look similar may
differ in voltage.
• Always replace both batteries at the same time.
• Do not expose batteries to heat or flame.
R6P(SUM-3)/AA(15F)
EN01-13.RX-9010VBK[C]f 01.4.13, 5:38 PM 13