Intel D865PCD - Manual (Page 99)

BIOS Setup Program
99
4.7.4 ATAPI CD-ROM Drives Submenu
To access this menu, select Boot on the menu bar and then ATAPI CD-ROM Drives.
Maintenance Main Advanced Security Power Boot Exit
Boot Device Priority
Hard Disk Drives
Removable Devices
ATAPI CD-ROM Drives
The submenu represented in Table 61 is for setting ATAPI CD-ROM drive priority.
Table 61. ATAPI CD-ROM Drives Submenu
Feature Options Description
1 st ATAPI CDROM
(Note)
Dependent on installed
ATAPI CD-ROM drives Specifies the boot sequence from the available
ATAPI CD-ROM drives. To specify boot sequence:
1. Select the boot device with < ↑> or <↓>.
2. Press to set the selection as the
intended boot device.
Note: This boot device submenu appears only if at least one boot device of this type is installed. This list will display up
to four ATAPI CD-ROM drives, the maximum number of ATAPI CD-ROM drives supported by the BIOS.
4.8 Exit Menu
To access this menu, select Exit from the menu bar at the top of the screen.
Maintenance Main Advanced Security Power Boot Exit
The menu represented in Table 62 is for exiting the BIOS Setup program, saving changes, and
loading and saving defaults.
Table 62. Exit Menu
Feature Description
Exit Saving Changes Exits and saves the changes in CMOS SRAM.
Exit Discarding Changes Exits without saving any changes made in the BIOS Setup program.
Load Optimal Defaults Loads the optimal default values for all the Setup options.
Load Custom Defaults Loads the custom defaults for Setup options.
Save Custom Defaults Saves the current values as custom defaults. Normally, the BIOS reads the
Setup values from flash memory. If this memory is corrupted, the BIOS reads the
custom defaults. If no custom defaults are set, the BIOS reads the factory
defaults.
Discard Changes Discards changes without exiting Setup. The option values present when the
computer was turned on are used.