IBM NETCOOL 4.3-W - Manual (Page 462)

Appendix A: Configuration
440 Netcool/Proviso Cisco IP Telephony Technology Pack User’s Guide, Version 4.3-W
Important: You will need to refer to this guide in order to run a Bulk inventory profile.
— Access to the Netcool/Proviso DataMart server.
— An X Window server on the DataMart server.
Note: (Pre-443 Netcool/Proviso) If there is no graphics card on the DataMart server, you can install the Xvfb
virtual frame buffer package to provide X Window services, as described in the Netcool/Proviso Installation
Guide .
— Access to the SilverStream server.
— Access to the DataChannel server.
• Have completed the following tasks:
— Installed the current version of the Netcool/Proviso components, as described in the Netcool/Proviso
Installation Guide.
— Installed the MIB-II technology pack
Note: Starting with version 4.3-T , the MIB-II Technology Pack no longer resides in the single bundled jar
file. It is a stand-alone technology pack that is contained in its own jar file.
— Installed the Cisco IP Telephony Technology Pack.
— Configured at least one DataChannel.
— Configured a UBA Bulk Collector subchannel.
— Configured an SNMP Collector subchannel.
Note: This technology pack contains a Java application, ProvisoCUCM, that sends data requests to CUCM
servers. The ProvisoCUCM application requires the Java Runtime Environment (JRE) version 1.5 or greater.
Configure the Technology Pack
To configure the Cisco IP Telephony Technology Pack, follow these steps:
Important: Localization is now done automatically during installation of the technology pack and requires no
manual steps to configure.
1. Load the DataMart environment.
To load the shell with the DataMart environment, follow these steps:
1-a. Log in to the DataMart server as pvuser.
1-b. Change your working directory to the DataMart home directory (
/opt/datamart
, by default), using
the following command:
cd /opt/datamart
1-c. Load the shell with the DataMart environment, by sourcing the
dataMart.env
file, as follows:
. /opt/datamart/dataMart.env
Note: After you load the DataMart environment into the shell, the PVMHOME variable is set to the
DataMart home directory, /opt/datamart by default. These instructions assume that this variable has been set.