Invacare 9000 SL - Manual (Page 61)

Part No. 1056953 61 9000 Series
CLEANING
WARNING
The user and O
2
cylinder must be removed from the wheelchair when
cleaning the O
2
holder. Otherwise, injury or damage may occur if cleaning
agents come in contact with the O
2
regulator.
1. Remove the user, any I.V. medication and the O
2
cylinder from the wheelchair.
2. The telescoping I.V. rod/O
2
holders clean easily with any household glass type cleaner.
3. After the cleaning solution has dried, it is safe for the user to re-occupy the wheel-
chair.
INSTALLING THE CRUTCH AND CANE CARRIER (FIGURE 2)
WARNING
Check base weekly to ensure proper placement.
When loading the crutch/cane carrier, ensure items are securely placed
into the base. Also ensure that there is no intereference with folding the
wheelchair, the rear wheels, or the swing-back arms.
Strap MUST be securely fastened while carrying items.
Never insert or remove items while wheelchair is moving.
1. Slide the clamp with the base attached over the end of the step tube of the wheelchair. Ensure
the base is towards the inside of the wheelchair.
2. Position the base parallel to the step tube.
CAUTION
Base should be parallel to step tube to avoid bending spokes when folding the
wheelchair.
3. Securely tighten the locknut that secures
the base to the step tube of the wheelchair.
4. Remove the upper back upholstery screw
and washer.
5. Align the strap with the back upholstery
screw mounting hole.
6. Reinstall the back upholstery screw and
washer and secure the strap to the wheel-
chair.
7. The base cleans easily with any chrome or
glass cleaner. The strap can be cleaned with
mild soap and water.
FIGURE 2 - INSTALLING THE
CRUTCH AND CANE CARRIER
Clamp
Strap
Base
Step
Tube
Locknut
OPTIONS SECTION 10
OPTIONS