Invacare 9000 SL - Manual (Page 27)

Part No. 1056953 27 9000 Series
FOOTPLATE HEIGHT ADJUSTMENT
SPRING BUTTON HEIGHT ADJUSTMENT (FIGURE 2)
NOTE: This procedure applies to the swingaway front riggings and swingaway elevating legrest.
1. Remove the front rigging assembly. Refer to INSTALLING/REMOVING THE
FRONT RIGGING in this section of the manual.
NOTE: Lay the front rigging assembly on a flat surface to simplify this procedure.
2. Pull the cam lock lever UP to UN-
LOCKED position.
NOTE: The elevating legrest has two (2) sets of
release buttons, one (1) set above the other.
Each set will be visible one at a time allowing
finer footplate height adjustment.
3. Push IN the release buttons and
reposition the footplate assembly to
the desired height.
4. Ensure that the release buttons fully
protrude from holes on both sides of
the front rigging support.
5. Rotate cam lock lever DOWN to
LOCKED position.
6. Repeat this procedure for the other
footplate, if necessary.
7. Reinstall the swingaway front rigging
assembly. Refer to INSTALLING/RE-
MOVING THE FRONT RIGGING in
this section of the manual.
FIGURE 2 - FOOTPLATE HEIGHT
ADJUSTMENT - SPRING BUTTON
HEIGHT ADJUSTMENT
NOTE: Swingaway footrest shown.
Front Rigging
Support
Footplate
Assembly
Cam Lock
Lever
Release Button
Adjustment
Holes
SECTION 3 FRONT RIGGINGS
FRONT
RIGGINGS