Invacare 9000 SL - Manual (Page 54)

9000 Series 54 Part No. 1056953
STORING/REPLACING THE
SPREADER BAR
STORING (FIGURE 5)
NOTE: The 9000XT RECLINER is folded for
either storage or transporting. One side of the
spreader bar must be removed and placed in a
vertical position along side the recliner tube.
Removing From The Stored
Position.
1. Rotate the end of the spreader bar 90 o
toward the opposite side frame.
2. Install threaded end of locking knob
into locknut located on the opposite
side frame. Securely tighten both
knobs.
Placing In The Stored Position.
1. Remove one (1) locking knob from the spreader bar.
2. Loosen the remaining locking knob on the spreader bar.
2. Rotate detached end of the spreader bar 90
o down toward floor.
REPLACING (FIGURE 6)
1. Remove both locking knobs that
secure the spreader bar to the side
frames.
2. Remove existing spreader bar.
3. Secure NEW spreader bar to the side
frames with the existing locking knobs.
Securely tighten.
FIGURE 6 - REPLACING THE
SPREADER BAR
Locking
Knobs
Side
Frame
Spreader
Bar
Side
Frame
Side
Frame
Spreader
Bar
Recliner
Tube
REAR VIEW OF 9000XT RECLINER
FIGURE 5 - STORING THE
SPREADER BAR
Locking
Knob
Locking
Knob
Threaded
End
RECLINER SECTION 9
RECLINER