Invacare 9000 SL - Manual (Page 56)

9000 Series 56 Part No. 1056953
REMOVING/INSTALLING THE REAR WHEELS
NOTE: If replacing the same size rear wheel, this procedure is performed.
WARNING
If changing the size of the rear wheel or if a change in the SEAT-TO-
FLOOR HEIGHT is desired, this procedure must be performed by a
qualified technician.
WITH PATIENT OPERATED
WHEEL LOCKS (FIGURE 8)
1. Remove the axle mounting screw and
locknut that secure the patient oper-
ated wheel lock, spacers, and rear
wheel to the wheelchair frame.
2. Secure rear wheel, patient operated
wheel lock, and spacers to wheelchair
frame with axle mounting screw and
locknut. Securely tighten.
3. Adjust the patient operated wheel
locks. Refer to USING/ADJUSTING
THE DISK WHEEL LOCKS in SEC-
TION 8 of this manual.
WITH ATTENDANT OPERATED WHEEL LOCKS (FIGURE 9)
1. Remove the axle mounting screw and
locknut that secure the rear wheel and
spacer to the wheelchair frame.
2. Remove rear wheel from side frame.
3. Secure rear wheel and spacer to
wheelchair frame with axle mounting
screw and locknut. Securely tighten.
4. Adjust the attendant operated wheel
locks. Refer to USING/ADJUSTING
WHEEL LOCKS in this section of this
manual. FIGURE 9 - REMOVING/
INSTALLING THE REAR WHEELS -
WITH ATTENDANT
OPERATED WHEEL LOCKS
Locknut
Wheelchair Frame
Rear Wheel
Axle
Mounting
Screw
Spacer
RECLINER SECTION 9
RECLINER
Spacers
Axle
Mounting
Screw
Patient Operated
Wheel Lock
Rear Wheel
Wheelchair Frame
Locknut
FIGURE 8 - REMOVING/
INSTALLING THE REAR WHEELS -
WITH PATIENT OPERATED
WHEEL LOCKS