beautypg.com

Installing the anti- tippers (figure 7) – Invacare 9000 SL User Manual

Page 55

background image

Part No. 1056953

55

9000 Series

INSTALLING THE ANTI-

TIPPERS (FIGURE 7)

1. Install the anti-rattles onto the rear

frame tubes if not already in place.

2. Position the anti-tippers with the anti-

tipper wheels pointing toward the

ground/floor

3. Press the release buttons IN.
4. Insert the anti-tippers into the rear

frame tubing until the bottom release

button locks in place.

NOTE: Refer to the following charts to ensure the correct anti-tipper is installed in the wheelchair.

Seat-to-Floor heights are approximate depending on front caster type. The anti-tipper height

measurement MUST be taken with the anti-tipper on a flat surface.

9000 XT RECLINER

WHEEL SIZE

SEAT-TO-FLOOR

ANTI-TIPPER

ON CHAIR

OFF CHAIR

REAR/CASTER

HEIGHT

LENGTH, HEIGHT

KIT NUMBER

24/8-inch

19-1/2-inches

11-1/2, 2-1/2-inches

1021767

1021767

22/8-inch

18-1/2-inches

10-1/4, 1-7/8-inches

1061110

1061110

20/8-inch

17-1/2-inches

10, 1-1/2-inches

1061109

1061109

Anti-Tipper Length

Flat Surface

Anti-Tipper

Height

Rear

Frame

Tubing

Release Buttons

FIGURE 7 - INSTALLING THE

ANTI-TIPPERS

Anti-tipper

Wheels

Anti-tipper

Anti-Rattle

SECTION 9

RECLINER

RECLINER