Icom IC-756 - Manual (Page 62)

59
8
SET MODE
■ Miscellaneous (others) set mode
(continued)
Speech speed
When the optional UT-102 VOICE SYNTHESIZER UNIT is
installed, you can select between faster or slower syn-
thesizer output.
See p. 61 for unit installation.
H I G H L O W
Faster announcement
(default) Slower announcement
Speech S-level
When the optional UT-102 VOICE SYNTHESIZER UNIT is
installed, you can have frequency, mode and signal
level announcement. Signal level announcement can
be deactivated if desired.
When “OFF” is selected, the signal level is not an-
nounced.
See p. 61 for unit installation.
O N O F F
Signal level announcement
(default) No signal level
announcement
Memo pad numbers
This item sets the number of memo pad channels
available. 5 or 10 memo pads can be set.
5 1 0
5 memo pads
(default) 10 memo pads
Mic up/down speed
This item sets the rate at which frequencies are
scanned when the microphone [UP]/[DN] switches
are pushed and held. High or low can be selected.
H I G H L O W
High speed (default,
50 tuning steps/sec.) Low speed
(25 tuning steps/sec.)
Speech synthesizer
When the optional UT-102 VOICE SYNTHESIZER UNIT is
installed, you can select between English and Japan-
ese as the language.
See p. 61 for unit installation.
E n g l i s h J a p a n e s e
English announcement
(default) Japanese announcement
Scope during tx
The spectrum scope shows the transmit signal wave-
form while transmitting. This can be deactivated if de-
sired.
When “OFF” is selected, the spectrum scope holds
the received waveform while transmitting and does
not show the transmit waveform.
O N O F F
Spectrum scope displays
the transmit waveform
(default) Spectrum scope does
not display the transmit
waveform