Icom IC-756 - Manual (Page 49)

46
5
MEMORY OPERATION
• Writing frequencies and operating
modes into memo pads
You can simply write the accessed readout frequency
and operating mode by pushing [MP-W].
When you write a 6th frequency and operating mode,
the oldest written frequency and operating mode are
automatically erased to make room for the new set-
tings.
NOTE: Each memo pad must have its own unique
combination of frequency and operating mode;
memo pads having identical settings cannot be
written.
■ Memo pads
The transceiver has a memo pad function to store fre-
quency and operating mode for easy write and recall.
The memo pads are separate from memory channels.
The default number of memo pads is 5, however, this
can be increased to 10 in set mode if desired. (p. 59)
Memo pads are convenient when you want to memo-
rize a frequency and operating mode temporarily, such
as when you find a DX station in a pile-up or when a
desired station is busy for a long time and you want to
temporarily search for other stations.
Use the transceiver’s memo pads instead of relying on
hastily scribbled notes that are easily misplaced.
Displayed frequency and mode
Push
Newest
The oldest written frequency
and mode are erased.
Oldest
MP-W
21.288.22
USB
21.276.00
USB
21.024.52
USB
21.018.06
USB
14.182.40
USB
14.195.00
USB
MEMO
PADS
• Calling up a frequency from a memo
pad
You can simply call up the desired frequency and op-
erating mode of a memo pad by pushing [MP-R] one
or more times.
- Both VFO and memory modes can be used.
- The frequency and operating mode are called up, starting
from the most recently written.
When you call up a frequency and an operating mode
from memo pads with [MP-R], the previously dis-
played frequency and operating mode are automati-
cally stored in a temporary pad. The frequency and
operating mode in the temporary pad can be recalled
by pushing [MP-R] one or more times.
- You may think there are 6 memo pads because 6 different
frequencies (5 are in memo pads and 1 is in the tempo-
rary pad) are called up by [MP-R].
NOTE: If you change the frequency or operating
mode called up from a memo pad with the tuning
dial, etc., the frequency and operating mode in the
temporary pad are erased.
VFO or MEMORY
mode display
MEMO PADS
TEMPORARY PAD
Push
Pushing [ MP-R ] calls up
the frequency and
operating mode in a
memo pad and the
temporary pad
sequentially.
Frequency and mode before
pushing [
MP-R ].
MP-R
21.485.00
USB
21.276.00
USB
21.024.52
USB
21.018.06
USB
14.182.40
USB
14.195.00
USB
14.195.00
USB