Intel IXM5414E User Manual
Page 230
![background image](/manuals/126082/230/background.png)
220
Intel® Blade Server Ethernet Switch Module IXM5414E
config acl rule action
Use this command to specify the action for the ACL and rule referenced by the parameters
and
Format
config acl rule action
config acl rule create
Use this command to create a rule within the ACL referenced by the parameter
identified by the
Default
deny
Format
config acl rule create
config acl rule delete
Use this command to remove a rule from the ACL referenced by the parameter
identified by the
Format
config acl rule delete
config acl rule match dstip
Use this command to specify a destination IP address and mask match condition for the ACL rule
referenced by the
4-digit dotted-decimal numbers which represent the destination IP address and IP mask,
respectively.
Format
config acl rule match dstip
config acl rule match dstl4port keyword
Use this command to specify a destination layer 4 port match condition for the ACL rule referenced
by the
and currently has the values of domain, echo, ftp, ftpdata, http, smtp, snmp, Telnet, tftp and www.
Each of these values translates into its equivalent port number, which is used as both the start and
end of a port range.
This command and the config acl match destl4port number command are two methods of
specifying the destination layer 4 port range as a match condition. Either command can be used to
configure or modify the destination layer 4 port range.
Format
config acl rule match dstl4port keyword
config acl rule match dstl4port number
Use this command to specify a destination layer 4 port match condition for the ACL rule referenced
by the
first and last ports that are part of the port range. They have values from 0 to 65535. The ending port
must have a value equal to or greater than the starting port. The starting port, ending port and all
ports in between will be part of the destination port range.
Either this command or the config acl match destl4port keyword command may be used to specify
a destination layer 4 port range as a match condition.
Format
config acl rule match dstl4port range