Intel IXM5414E - Manual (Page 224)

214 Intel® Blade Server Ethernet Switch Module IXM5414E
Accounting Retransmissions
The number of RADIUS accounting request packets retransmitted to this
accounting server.
Accounting Responses
The number of RADIUS packets received from this accounting server.
Malformed Accounting Responses
The number of malformed RADIUS accounting response packets received from this
accounting server, including packets with invalid length but not including packets
with bad authenticators or unknown types.
Bad Authenticators
The number of RADIUS accounting response packets received from this accounting
server, including packets with invalid authenticators.
Pending Requests
The number of RADIUS accounting request packets sent to this accounting server
that have not yet timed out or received a response.
Timeouts The number of RADIUS packets sent to this accounting server that have timed out.
Unknown Types
The number of RADIUS packets of unknown type received from this accounting
server.
Packets Dropped
The number of RADIUS packets received from this accounting server dropped for a
reason not otherwise included in this list.
show radius accounting summary
Use this command to display a summary of the RADIUS accounting configuration parameters for
the switch.
Format show radius accounting summary
Accounting Mode
Indicates whether accounting mode is enabled or disabled.
IP Address The IP address of the RADIUS accounting server currently in use.
Port The port used to access the accounting server.
Secret configured
Indicates whether a secret has been configured for the accounting server.
RADIUS configuration / summary commands
clear radius stats
Use this command to reset all RADIUS statistics for the switch. You will be prompted to confirm
this choice.
Format clear radius stats
config radius maxretransmit
Use this command to configure the maximum number of times a request packet is retransmitted
when no response is received from the RADIUS server. The maxretransmit value is an integer in the
range of 1 and 15.
Consideration should be given to the maximum delay time when configuring RADIUS
maxretransmit and timeout values. If multiple RADIUS servers are configured, the maxretransmit