Intel IXM5414E - Manual (Page 201)

Intel® Blade Server Ethernet Switch Module IXM5414E 191
config igmpsnooping mcrtrexpiretime
Use this command to configure the Multicast Router Present Expiration time on the switch module.
This is the amount of time in seconds that a switch will wait for a query to be received on an
interface before the interface is removed from the list of interfaces with multicast routers attached.
The range is 0 to 3600 seconds. A value of 0 indicates an infinite timeout, i.e. the time never expires.
Default 0
Format config igmpsnooping mcrtrexpiretime <0-3600>
show igmpsnooping
Use this command to display IGMP Snooping information for the IXM5414E switch module.
Configuration information is displayed whether or not IGMP Snooping is enabled. Status
information is only displayed when IGMP Snooping is enabled.
Format show igmpsnooping
Admin Mode
This indicates whether or not IGMP Snooping is enabled on the switch.
Group Membership Interval (secs)
This displays the IGMP Query Interval Time. This is the amount of time the switch
will wait for a report for a particular group on a particular interface before it sends a
query on that interface.
Max Response Time (secs)
This displays the amount of time the switch will wait after sending a query on an
interface because it did not receive a report for a particular group on that interface.
Multicast Router Present Expiration Time (secs)
If a query is not received on an interface within this amount of time, the interface is
removed from the list of interfaces with multicast routers attached.
Interfaces Enabled for IGMP Snooping
This is the list of interfaces on which IGMP Snooping is enabled.
The following status value is only displayed when IGMP Snooping is enabled.
Multicast Control Frame Count
This displays the number of multicast control packets that have been processed by
the CPU.
Link Aggregation (LAG) commands
config lag addport
Use this command to add a physical port to a LAG. The first interface parameter designation is of a
configured LAG and the second identifies the port to be added. There can be a maximum of 8
member ports.
Format config lag addport
config lag adminmode
Use this command to enable or disable the specified LAG(s). The option sets every configured
LAG to the same administrative mode setting.
Format config lag adminmode