Intel IXM5414E - Manual (Page 229)

Intel® Blade Server Ethernet Switch Module IXM5414E 219
Mode Privileged EXEC
Secure-Server Administrative Mode
Indicates whether the administrative mode of secure HTTP is enabled or disabled.
Secure Protocol Level
The protocol level may have the values of SSL3, TSL1 or both.
Secure Port Specifies the port configured for SSL.
HTTP Mode Indicates whether the HTTP mode is enabled or disabled.
Quality of Service (QoS) commands
This section describes the commands used to configure and manage the Quality of Service (QoS)
features of the Intel® Blade Server Ethernet Switch Module IXM5414E. These features include:
• Access Control Lists (ACLs)
• Bandwidth provisioning
Access Control List (ACL) commands
An ACL consists of a set of rules which are matched sequentially against a packet. When a packet
meets the match criteria of a rule, the specified rule action (permit/deny) is taken and the additional
rules are not checked for a match. This section describes the commands you use to specify the
interfaces to which an ACL applies, whether it applies to inbound or outbound traffic and its match
criteria.
config acl create
Use this command to create an ACL identified by the parameter . The ACL number is an
integer from 1 to 100.
Format config acl create
config acl delete
Use this command to delete an ACL identified by the parameter from the system.
Format config acl delete
config acl interface add
Use this command to associate an ACL with an interface and specifies whether it affects inbound or
outbound traffic. The parameter can have the values of in or out. The parameter
specifies the ACL to add.
Format config acl interface add
config acl interface remove
Use this command to disassociate an ACL from an interface for the specified direction. The
parameter can have the values of in or out. The parameter specifies the ACL to
remove.
Format config acl interface remove