Intel IXM5414E User Manual
Page 226
216
Intel® Blade Server Ethernet Switch Module IXM5414E
RADIUS server commands
config radius server add
Use this command to configure the IP address used to connect to a RADIUS server. Up to three
servers can be configured for each RADIUS client. If three servers are currently configured, one
must be removed using the config radius server remove command before the add command will
succeed. Once a server has been added it will be identified in future commands by its IP address.
Format
config radius server add
config radius server msgauth
Use this command to enable or disable the message authenticator attribute for the specified RADIUS
server. Enabling the message authenticator attribute provides additional security for the connection
between the RADIUS client and server. Some RADIUS servers require that the message
authenticator attribute be enabled before authentication requests from the RADIUS client will be
accepted. The IP address specified must match that of a configured server.
Format
config radius server msgauth
config radius server port
Use this command to configure which UDP port will be used to access the specified RADIUS
server. The IP address specified must match that of the previously configured RADIUS server.
Default
1812
Format
config radius server port
config radius server primary
Use this command to specify which configured server should be the primary server for this RADIUS
client. The primary is the server that is used by default for handling RADIUS requests. The
remaining configured servers are used only if the primary server cannot be reached. A maximum of
three servers can be configured on each client. Only one server can be configured as the primary
server. If a primary server is currently configured and this command is issued, the server specified
by the IP address used in this command will become the new primary server. The IP address
specified must match that of a configured server.
Format
config radius server primary
config radius server remove
Use this command to remove a configured RADIUS server. The IP address specified must match
that of the previously configured RADIUS server. When a server is removed all configuration for
the server is erased including the shared secret. If the removed server was the primary server, one of
the remaining configured servers will be used as the RADIUS server for future RADIUS requests.
Format
config radius server remove
config radius server secret
Use this command to configure the secret shared between the RADIUS client and server. A secret
must be configured for each RADIUS server. The IP address specified must match that of a
previously configured RADIUS server. When you enter this command, you will be prompted to
enter the secret, which must be an alphanumeric value of 20 characters or less.
Format
config radius server secret
show radius server stats
Use this command to display the statistics for a configured RADIUS server.
Format
show radius server stats