Iomega SBG1000 - Manual (Page 25)

19 SBG1000 Wireless Cable Modem Gateway User Guide
Home
X
Exit Print
Overview Installation Troubleshooting Contact FAQ Specifications Glossary License
Configuration: Basic Gateway TCP/IP Wireless Print Server USB
Installation
To install the Motorola SBG1000 Wireless Cable Modem Gateway hardware:
•
Determine the type of connections you will make to the SBG1000 — Ethernet, HPNA, wireless, USB, and/or
printer
•
Check that you have the proper cables, adapters, and adapter software to connect to your SBG1000:
— For Ethernet, you’ll need Ethernet cables and network interface cards ( NICs ) with accompanying
installation software.
— For HPNA, you’ll need telephone jumper cables, HPNA interface cards, and the installation software.
— For wireless connections, you’ll need wireless adapters and the installation software for the adapters.
— For USB, you’ll need a USB cable and the Motorola SBG1000 Wireless Cable Modem Gateway
CD-ROM which contains the software for USB installation.
— For the printer, you’ll need a printer cable.
Before You Begin
Before you begin the installation, check that you received the following items with the Motorola SBG1000 Wireless
Cable Modem Gateway:
You will need 75-ohm coaxial cable with F-type connectors to connect the SBG1000 to the nearest cable outlet. If
a TV is connected to the cable outlet, you may need a 5-900 MHz RF splitter and two additional coaxial cables to
use both the TV and the SBG1000.
Item Description
Power cord Connects the SBG1000 to the AC electrical outlet
10/100Base-T
Ethernet cable Connects to the Ethernet port
USB cable Connects to the USB port
Phone wire jumper
with RJ-11 connectors Connects to a telephone line used for the HPNA network
Motorola SBG1000
Wireless Cable Modem
Gateway CD-ROM Contains this User Guide and USB drivers