beautypg.com

Startup – Multiquip MQ Power 60 Hz Generator DCA25USI2XF User Manual

Page 33

background image

1

DCA25USIXF/DCA25USI2XF — OPERATION AND PARTS MANUAL — REV. #2 (07/26/11) — PAGE 33

The engine's exhaust contains harmful emissions.
ALWAYS have adequate ventilation when operating.
Direct exhaust away from nearby personnel.

Before Starting

CAUTION - LETHAL EXHAUST HAZARD

2. In warm weather conditions, skip to step 3. Preheat the

engine

glow plugs by turning the ignition key

(Figure 41) to the RUN position. When the preheat lamp
(Figure 42) illuminates, proceed to step 3.

Figure 42. Pre-Heat Indicator Lamp

Figure 41. Ignition Switch Pre-Heat

(Run Position)

1. Place the

voltage selector switch in the desired voltage

position (Figure 40).

Figure 40. Voltage

Selector Switch

INCORRECT

CORRECT

2. Connect the load to the

receptacles or the Output

Terminal Lugs as shown in (Figure 11). These load
connection points can be found on the output terminal
panel and the output terminal panel’s hard wire hookup
panel.

3. The output terminal lugs are protected by a plastic cover.

Remove this cover to gain access to the terminals.
Tighten terminal nuts securely to prevent load wires from
slipping out.

4. Close all engine enclosure doors (Figure 39).

Figure 39. Engine Enclosure Doors

1. Place the

main, G.F.C.I., and aux. circuit breakers

(Figure 38) in the OFF position prior to starting the engine.

Figure 38. Main, Aux. and GFCI

Circuit Breakers (OFF)

NEVER! manually start the engine with the main, GFCI
or

auxiliary circuit breakers in the ON (closed) position.

WARNING - STARTING THE GENERATOR

Start-up Procedure

STARTUP

This manual is related to the following products: