Moog DS2100 - Manual (Page 66)

DS2100 User's Manual (Preliminary)
SECTION 3: WIRING AND INSTALLATION
PAGE 3-60
3.12.2 General Purpose Description of the Digital Outputs
The DS2100 provides 4 digital outputs on connector J2B & J2C. Only the digital outputs on J2B are detailed here.
- Fixed connector: 5 pins, male connector
- Mating connector, 5 pins spring cage, female, supplied with the drive. Phoenix Contact (Part # FK-MC 0.5/5-ST-
2.5)
- Wiring: cable. 28-20AWG (0.14-0.5mm 2 )
- Wire stripping: 8 mm
Pos. Name Function
J2B.1 Ext 24V DC +24V Digital Output Supply
J2B.2 O1 Digital Output #1 User Configurable
J2B.3 O2 Digital Output #2 User Configurable
J2B.4 O3 Digital Output #3 User Configurable
J2B.5 Ext 24V Ret Digital Output Return
Table 3.27 J2B, DS2100 Digital Output connector
The following electrical description applies to all, except one, of the digital outputs of the DS2100. (One digital output,
Drive Ready, uses a relay rather than an opto-coupler).
47k W
Optocoupler Isolation DGND
Ext 24VRet
O1-O3
Ext 24V DC
High Side
Switch
47k W
Figure 3.42 DS2100 Generic Digital Outputs
Note that:-
§
Voltage Range is 6V to 32V from Digital-Output to the O_COMMON line. Digital outputs switch only DC
voltages.
§
Output current ≥ 250 mA, off state leakage current ≤ 100 µA at 0 V.
§
Short circuit protected, inductive load driving capability, reverse polarity protected. Protected for supply voltage
range of -40 V to +40 V.
§
All digital outputs are optically isolated for noise immunity purposes. All DS2100 digital outputs are isolated
from high voltage circuitry.
§
Current flowing in the digital output implies the function is active.