Ds2100 user's manual (preliminary), 4 d size regeneration resistor connection – Moog DS2100 User Manual
Page 47

SECTION 3: WIRING AND INSTALLATION
DS2100 User's Manual (Preliminary)
PAGE 3-41
3.10.4 D Size Regeneration Resistor connection
Tie screen to
panel on
which resistor
is mounted.
Tie Screen to
chassis via EMC
bracket. See
Section 2
Installation
J9.2 J9.1
DC+(RR) RR
Connector J9
DS2100 D
Recovery
Resistor
Figure 3.28 DS2100 Size D External Regeneration Connections
J9
-
Fixed connector: 2 pole, screw terminal
-
D size wiring: cable 6 AWG (13 mm
2
) for 50/140
-
D size wiring: cable 4 AWG ( 21mm
2
) for 60/180
-
Stripping Length 16mm
-
Tightening Torque: 2-2.3Nm
Pos.
Name
Function
J9.1
RR
Regeneration Resistor
J9.2
DC+(RR)
DC Bus (+)
Table 3.17 J9, Regeneration Resistor connector, D Size
WARNING - When performing any changes to the regen resistor configuration,
a.c. input power must be removed from the DS2100. Wait 5 minutes upon
removal of all power, to allow for D.C. Bus capacitors to discharge.