Motorola PTP 400 Series User Manual

Page 75

• Running at maximum receive mode:

The wireless link is operating at its receive maximum capacity. To confirm that the

wireless link is operating at its maximum transmit capacity either look at the 'Transmit

Modulation Mode' on this page or look at the peer wireless units 'Receive Modulation

Mode Detail' attribute.

• Running at user-configured Target Modulation Mode:

This indicates that the wireless link could operate at a higher capacity but has been

limited in modulation mode by the user from the configuration page.

• Restricted because Installation is armed:

During installation the wireless link is restricted to operate in a low order modulation

mode (BPSK ½ ). Disarming the wireless units after installation will allow the wireless link

to adaptively select its own operational modulation mode.

• Restricted because of byte errors on the wireless link:

During normal operation the wireless link monitors its performance. If byte errors are

detected during normal data transmission / reception the wireless unit automatically

changes the active modulation mode to a more robust mode in order to reduce the

number of errors.

• Restricted because a DFS channel change is in progress:

During Spectrum Management (DFS) channel changes the wireless unit temporarily

reduces the modulation mode to BPSK ½.

• Restricted due to the low Ehthernet link speed:

If the Ethernet link speed is less that the instantaneous wireless link capacity then the

modulation mode is optimized so that the Ethernet link speed is satisfied using the most

robust modulation mode.

• Limited by the wireless conditions:

The wireless link capacity is limited by the current wireless conditions e.g. interference,

excess path loss, etc…

Range:

The range

between the peer PTP 400 Series Bridge units.

Refresh Page Period:

The Status page refreshes automatically according ti the setting

entered here (in seconds).

The 400 Series Bridge displays range in km by default, if the user would prefer to display range

using Miles the ‘Distance Units’ attribute should be set to imperial, see the “

” web page

section 8.3.19

Properties

This option is only available to the System Administrator