Motorola PTP 400 Series - Manual (Page 129)

127
8.3.12 SNMP (Simple Network Management Protocol)
The industry standard remote management technique is SNMP (Simple Network
Management Protocol). The PTP 400 Series Bridge supports version 1 and version 2c of the
SNMP protocol.
8.3.12.1 Supported Management Information Bases (MIBS)
The industry standard remote management technique is SNMP (Simple Network
Management Protocol). The PTP 400 Series Bridge supports SNMP version 1 and version 2.
The PTP 400 Series Bridge SNMP stack currently supports four distinct MIBs:
1. MIB-II, RFC-1213, The PTP 400 Series Bridge supports the ‘System Group’ and
‘Interfaces Group’.
2. Bridge MIB, RFC-1493, The PTP 400 Series Bridge supports the ‘dot1dBase Group’ and
the ‘dot1dBasePortTable Group’.
3. PTP 400 Series Bridge proprietary MIB
4. WiMAX MIB
SNMP TRAPs supported:
• Cold Start
• Link Up
• Link Down
• DFS Channel Change
• DFS Impulsive Interference
For a copy of the Motorola proprietary version 1 and version 2 MIB RFCs please consult the
installation CD.
8.3.12.2 SNMP Configuration
SNMP State: The SNMP state attribute controls the creation of the SNMP features. Changing
the SNMP state attribute requires a mandatory reboot of the unit. Only when the SNMP state
is enabled at system start-up will the SNMP processor task be created.
SNMP Enabled Traps: The SNMP Enabled Traps attribute controls which SNMP traps the
unit will send.
SNMP Trap Version: This determines which SNMP trap version the unit will send: version 1
or version 2c.