Motorola PTP 400 Series User Manual
Page 141
139
Power Indoor Unit LED check chart:
Mode
Green
LED
Yellow LED No
Ethernet Cable
Connected
Yellow LED Ethernet Cable
Connected between PIDU Plus and
NIC/Switch/Hub
No Power Applied
Off
Off
Off
Power Applied
On
Will flash once per
second regularly
approximately 16
seconds after power
applied for 10
seconds then will go
out and stay out
Will flash regularly once per second
approximately 16 seconds after
power applied for 10 seconds then
operate as Ethernet Link/Activity
LED
Valid Ethernet Link and
no traffic
On
N/A
Will be on solid for a valid link.
Valid Ethernet Link with
traffic
On N/A
Will be on solid, but will blink
randomly as traffic passes through
While Recovery Switch
Pressed
On Off
Off
Recovery Switch Pressed
and released within 10
seconds during normal
operation
On Off
Off while switch pressed but returns
to LINK/Activity state when
released. No reset will take place
Recovery Switch Pressed
and held for > 20
seconds during normal
operation
On
Off while switch pressed.
One second after release, flashes twice per second
regularly for 10 seconds, then erases non-volatile
configuration data and resets. The erasure will reset all the
unit's configuration apart from the last known wireless link
configuration. This ensures that after a reset the wireless
link SHOULD re-establish without any user intervention.
The IP address will be reset to 169.254.1.1
Recovery Switch Pressed
and held for >40 seconds
from power on (Recovery
is pressed while power is
applied)
On
Off while switch pressed.
One second after release, flashes regularly twice per
second for 10 seconds. Then erases non-volatile
configuration data & the downloaded image and resets.
The erasure will reset all the unit's configuration apart from
the last known wireless link configuration. This ensures that
after a reset the wireless link SHOULD re-establish without
any user intervention.
The IP address will be reset to 169.254.1.1 and the unit will
boot the fixed software image.
27
It is possible that some units may have been previously configured with IP addresses 10.10.10.10
(Slave) and 10.10.10.11 (Master). Therefore the IP address will be reset to 10.10.10.10/11.