Metz LCD-TV None - Manual (Page 72)

72
The signal type always refers to the input
and output of the AV device.
Some AV devices may use a composite video sig-
nal (FBAS) for recording and playback operations
and an RGB signal for displaying their menus.
It is not possible to make a general statement in
this respect. The operating instructions of the AV
device concerned may provide some indication.
If you connect such an AV device with the signal
type "composite video" (FBAS) and recordings are
played back correctly, but you cannot see the
menu of the AV device, you must change the sig-
nal type in the menu "AV devices" to "RGB".
Setting the signal type
• Press the "MENU" key to open the TV menu.
• Press the yellow key to
open the menu "AV devi-
ces".
• Use the cursor control key to
select the AV device whose
signal type you wish to
change and press the "OK"
key.
• Press numeric key
·
, use
the cursor control key to
select " Signal OUT", and
use the - + key to change
the setting to " RGB".
• Press the "OK" key to confirm your selection.
• Press the "EXIT" key to close the TV menu.
☞
25. Registering AV Devices
Setting signal types RGB
MENU
OK
ᕢ
OK
EXIT
Opening the menu
Caution ! This may cause an existing connection diagram to be
modified. If so, you must reconnect the AV devices accordingly.
☞
Signal OUT RGB Signal IN CVBS
DataLogic
Name
Signal types
connect
HiFi amplifier
AV-Receiver
Other device 2
Other device 1
PC
Satellit / set top
DVD Player 2
DVD Player 1
DVD/Videorec.2
DVD/Videorec.1
F1 ➔
✗
AV devices
Change with
Accept value with .
OK
– +
606 47 2030.A1 ML GB 16.04.2007 12:34 Uhr Seite 72