Metz LCD-TV None - Manual (Page 30)

30
12.1 Sound Settings for
Programmes via TV Menu
Some of the menu items are not available
in a 2 ** menu.
Forced mono
It may happen that your TV set switches from
mono to stereo in the middle of a programme, alt-
hough no stereo sound is being transmitted. This is
generally caused by the local reception condi-
tions. If you activate "Forced mono" for the selec-
ted programme position, all
programmes from this station
will be reproduced in mono.
Activating forced mono:
• Press the "MENU" key.
The TV menu appears on
the screen.
•Press the blue key . The
menu
"Picture and sound" and the
menu
item "General picture set-
tings" are
pre-selected.
• Use the corresponding numeric key (in the
example:
¿
) to select "Sound settings for Pr.".
• Use the corresponding numeric key (in the
example:
»
) to select "Forced mono".
• In the setting window, use the - + key to change
the setting.
• Press the "OK" key to save the new settings.
• Press the "EXIT" key to close the TV menu.
Individual sound settings can also be made
in the station table.
☞
☞
Opening the menu
MENU
ᕤ ᕣ
OK
EXIT
The number of subjects and sections depends
on the selected scope of operation. Depending
on the configuration of the TV set, the various
menu items may be displayed in a different
order and numbered differently.
7) Available only for analogue stations!
Forced mono on
Forced mono 7)
Tone settings
Volume correction
Sound set,.prog.posn
Sound settings, gen.
Pict.set.,prog.posn.
Picture settings, gen.
Picture-Volume
Change with
Accept value with
– +
OK
606 47 2030.A1 ML GB 16.04.2007 12:34 Uhr Seite 30