Metz LCD-TV None - Manual (Page 52)

52
NexTView data 8) is transmitted by
various broadcasting organizations.
DVB-SI
data is broadcast by each chan-
nel corresponding to its own content.
Information may therefore correspondin-
gly vary.
Switch on your TV, so that EPG data can
be compiled and/or updated. While
data is being compiled the green LED is
lit.
TV sets with one receiver unit:
• If a NexTView slot
8) has been set:
Switch the TV to standby mode, using
the mains key on your remote.
• If no NexTView slot 8) has been set and
only DVB-SI details can be received:
switch the set to standby.
After switching on the TV, data
compilation will continue stop until
it is switched to standby again.
☞
Special notes:
The TV set’s channel table lists all availa-
ble channels in the programme guide,
provided you do not make another
selection in the channel table menu.
Channels broadcasting on a time-shared
basis – e.g. arte/Kinderkanal – must be
saved in separate programme slots (see
24). If you include all channels in the
EPG, you won’t be able to see very far
ahead.
You can decide which channels should
appear in the EPG programme guide.
As a rule, the collection process gathers
data for all free channels. The following
options are available to exclude selected
channels from the EPG programme gui-
de:
Solution 1:
• Press the MENU key. The TV menu
appears on the screen.
• Press the white key . The menu
channel table appears with the active
programme slot selected.
• Press F2 to permit editing of the chan-
nel list.
• Press ̈ to switch to the menu page.
• Using ̆ and ̄ select “Include channel
in EPG” and dedeselect rows marked
(x) with OK.
• To exclude other channels from the
EPG programme guide, use ̇ ̈ ̆
and ̄ to select the channel and
repeatthe procedure.
20.2 Collecting EPG data
Not possible with an external receiver !
606 47 2030.A1 ML GB 16.04.2007 12:34 Uhr Seite 52