Metz LCD-TV None - Manual (Page 62)

62
The TV set will normally detect the colour standard
(PAL, SECAM, NTSC, NTSC44, PAL60, PAL M)
automatically.
If this automatic selection does not provide satis-
factory results (which should happen only rarely),
you can select the colour standard manually for
each programme position.
The colour standard is set in the factory to "Auto-
matic".
Setting the colour standard
• Press the "MENU" key to open the TV menu.
• Press the white key to open the station table.
• Press the F2 key to enable
editing of the station table.
• Use the cursor control key to
select the programme posi-
tion whose colour standard
you wish to change.
• Press the cursor control key
̈ to move to the left
column.
• Use the corresponding
numeric key (in the exam-
ple:
ᕩ
) to select
"Colour standard".
• Use the - + key to select the desired colour stan-
dard, or to step through the available colour
standards until the picture is displayed clearly.
• Press the "OK" key to confirm your selection.
• Press the "EXIT" key to close the TV menu.
Opening the menu
22.1 Setting Stations
Colour standard for analogue stations
The number of subjects and sections depends
on the selected scope of operation. Depending
on the configuration of the TV set, the various
menu items may be displayed in a different
order and numbered differently.
MENU
F2
EXIT
ᕩ
OK
Colour standard SECAM
Sound corrections
Colour standard 3) 7)
Picture quality
Picture correct.
Enter logo
Station contained in EPG
CA module 5)
Signal quality 5)
DVB-prog. info 5)
Frequency/channel 7)
0010 Hessen 3
0009 Südwest
0008 MDR
0007 PRO 7
0006 RTL 2
0005 RTL
0004 SAT 1
0003 Bayern 3
0002 ZDF
0001 ARD
Station table
Change with
Accept value with
– +
OK
✗
F1 ➔
3) See glossary for an explanation.
5) Available only for DVB stations!
7) Available only for analogue stations!
606 47 2030.A1 ML GB 16.04.2007 12:34 Uhr Seite 62