MicroNet Technology SP5001/S - Manual (Page 66)

65
Parameter Usages:
-status Display the enabled debug flags.
-add Add debug flag.
-sip sip related information
-msg voice related information
-delete Remove specified debug flag.
-open Start to show debug messages.
-close Stop showing debug messages.
usr/config$ debug -status
Current debug type enabled :
Debug Mode is close
DEBUG->
usr/config$
Figure 39. debug –print command list
19.7.3 [reboot]
After commit command, type reboot to reload SP5001/S in new configuration.
The procedure is as below:
usr/config$ reboot
. Rebooting...It will take 40 seconds....Attached TCP/IP interface to
cpm unit 0
Attaching interface lo0...done
HTTPD initialized...
Flash Check
WorkMode : PROXY_MODE
Start registering to Proxy server
AC4804[0] is ok
successful 1 2
Initialize OSS libraries...OK!
VP v1.42 stack open successfully.
login:
Figure 40. reboot command list