MicroNet Technology SP5001/S User Manual
Page 60
59
>Advanced setting > NAT setting > Port Redirection
Active Configuration
Items
Service name Protocol
Actual Port Virtual IP
Virtual Port Enable
1
1
UDP
5060
192.168.1.10
5060
v
2
2
UDP
16384
192.168.1.10
16384
v
3
3
UDP
16394
192.168.1.10
16394
v
4
4
UDP
5061
192.168.1.11
5061
v
5
5
UDP
26384
192.168.1.11
26384
v
6
6
UDP
26394
192.168.1.11
26394
v
7
---
0
0
x
8
---
0
0
x
9
---
0
0
x
10
---
0
0
x
Note:
1.
Different Vendor’s Router will have different appearance of setting.
2.
Once you set the DMZ Host, you don’t need to configure the Port
Forwarding and vice versa.
3.
If there is only one SP5001/S attached to the IP Sharing device, it is
recommended to use DMZ Host setting to enable the NAT traverse and
disable the Port Forwarding.
4.
If there are two or more sets of SP5001/S attached to the IP -Sharing
device, please configure the Port Redirection (Forwarding) to enable the
NAT traverse and disable the DMZ Host.
5.
After the IP Sharing configuration of SP5001/S and IP Sharing device is
complete, you must reboot SP5001/S to activate the new settings.